Recent content by mr280
-
M
New to the Group from PA
I'm not an ex-military sniper, LEO or anything like that. Been range shooting, reloading and working on my own guns for about ten years. Would like to get into longer range shooting if there was a range where I could shoot farther than two hundreds yards in my area. Mainly into 308, 280 and 7MM...- mr280
- Thread
- Replies: 2
- Forum: New Member Introduction
-
M
When to bump shoulder back?
The Book of Rifle Accuracy by Tony Boyer has a good section on this issue. I usually only full length re-size when my brass is hard to chamber or extract. That's just my opinion.- mr280
- Post #5
- Forum: Reloading Depot
-
M
New 280AI build... big problems
I'll tell you what I did back when I built my 280 Ackley from a 25-06 Savage I had. Since at least some brass was to be fire-formed from 280 Remington - the rest I made by fire-forming 30-06, 270 and 25-06 using the "Cream of Wheat" method. First, I pulled the bullet from a factory fresh 280...- mr280
- Post #6
- Forum: Bolt Action Rifles
