Recent content by mrgreen

PM sent.

No more calls, we have a winner! A Mr. porgiefirefighter comments; "Fat guns, skinny guns, guns that climb on rocks. Tough guns, sissy guns, even guns with chickenpox." I tried to post this earlier, but I needed to clean coffee from my keyboard.

Wil, I've used this one for a few years. BDS Medical Fanny Pack. It's worked for me on the range and hunting/scouting. Not too big, I just added a nalgene holder.

It was a nice run. AMF. unsubscribed.

I have the Belt Knife. I like it a lot and carry it whenever I'm in the woods. Last season I used it to cut through the ribcage on two deer, no problems. After the field use, I washed it off and used it to cut the backstraps and veg for stir-fry. Holds an edge well, mine has the micarta grips...

Huh! Finland, Really? I need to look into that.

Damn! Where can this happen? And how do I get there?

Does anyone have a shorty in a Manners Elite folder? I'm interested in the weight and portability.

It looks like their Crossbow Sling. Found the website, but it only shows 2-point slings. Confections Carcajou Hope that helps.

Saw that happen years ago. Alcohol-based pepper spray + Taser= Johnny Human Torch. DOH!

On more then one occasion, you had to give one of your BUGs to a teammate. Because half way to the job-in-progress he realized he left his pistol in his locker, but said he knew you would have a "spare".

Update- Just installed the Timney. It couldn't have taken more then 10 minutes, start-to-finish. Ordered direct from Timney, m510 w/long sear, set at 2.5 lbs. I spoke the them about the Calvin Elite, when I explained it was for hunting and #2.5 was as low as I planned to go, they suggested the...

Here's mine after a couple of days at the range. Real happy with it. Shooting FGMM 168gr at 100 yards. By the way my first time shooting prone. Anyway, now that everything seems to have come together, I'll be taking it apart to install a Timney trigger. Thanks Remington! Rem 700 AAC 16.5...

Thanks guys, I heard back from McMillan. They agree with you, there should be enough room. Very little, if any, to remove. I placed my order with Timney by phone last night (they seem to be putting in a lot of overtime, thanks to Rems recall). DaveT, thanks for the heads up re; the U-sear...

In light of the Rem 700 trigger recall, it seems like the right time to swap out the trigger. I'm trying to decide if it's a DIY or find-a-Gunsmith situation. Since the Timney 510 and Mcm HTG Stocks seem to be very popular here, does anyone have experience fitting one into the other? Is there...