Recent content by Nathan Gravitt

Seconds, If these are SRP

I’ll take it

I’ll take these. PM with payment details

It’s yours, my buddy didn’t respond

Okay, thanks, my buddy is looking for one so I’ll let him know

Did this sell?

What coating is on the barrel and stock?

I’ll take one. Pm with payment details

I’ll take it if it’s not sold. Pm incoming

I have a shilen select match varmint barrel with only about 50 rounds on it. 1-8 twist. 26” Threaded 5/8-24 if you are interested shoot me a pm. $375 shipped

Hey guys, SHOCK316 is a friend of mine. He came on the site because I sent him the link for the scope since he was considering purchasing one. Although he was mistaken on price, I can vouch for him that he is a stand-up guy. So I hope he and the OP can work something out.

Finally got everything finished up. I wanted to show pictures all along the way. Hopefully it may encourage some of you to go ahead and try it! If I had it to do over again I would have made sure that the bottom hardware was flush with the stock rather than trying to recess it. Also, the bottom...

The last step was to bondo any voids. After taping everything up, I bondoed any voids, and then hand sanded with a block. I then primed and painted black. I plan on doing a camo sponge job that I will post when I finish

Ok, I feel like this is the most critical step. Drilling the hole through the stock. I layed out the stock on both sides and drilled a 9/16” hole from both sides. The hardware is 1/2”. After drilling, test fit the hardware. As a side note, I decided to recess the hardware 1/16” so there would be...

Back from vacation. I marked out the top piece with a razor blade. I just scored around it once I centered it up. I have a small laminate router that I put a 1/4” bit into. I set the depth of the router to match the hardware depth. I then took off about 1/8” per pass until I got it right to the...