Recent content by Nesika

DetroitRearView, I am also looking at a 22" 338 conversion. Would you care to share your load data including bullet type and velocity to help me crunch the numbers? Thanks

Update on the misfire issue; I tried another LOT of CCI 250 and had no issues, I traced the issue to a single 100 box of CCI 250's that I believe I stored incorrectly as they were sitting on my bench next to copper piping which was dripping with water droplets due to the very hot and humid...

I stripped and oiled the bolt as suggested and found no debris but the bolt was slicker so it was worth the exercise. Ran the 338 in the final stages of load developement over the weekend and found: Fed215M - No Misfires Rem 91/2M - No Misfires WLRM - No Misfires CCI250 - 50% misfires...

Thanks mil_coder. Unfortunately I am stuck with the company Blackberry. I don't want to carry two phones so do you know of any android device that will run Applied Ballistics Mobile program.

Thanks guys, I will strip the bolt and take a look. I am sure that it will be easily resolved. Just a side note this one of the most accurate rifles I have owned (and I have many custom rifles), she is shooting sub 1/2 MOA and have shot sub 1/4 MOA with the 300 grain Hybrid UNBELIVEABLE for a...

Yes primer seating depth is uniform, I have not measured the overall length of the firing pin but can do that easily. Do you have a spec for the overall length?

Has anyone had any issues with lite firing pin strikes on their DTA SRS-A1? Just going through load development with my new .338 Lapua, have about 50 rounds down the pipe and in the final stages of load development but on the last range session I got 5 lite strikes out of 15 rounds! Any...

Will Applied Ballistics mobile work on a Blackberry Z10?