Recent content by NLivingston

Dropping some links to some recent videos we did on our new mounts. Although my bias is obvious, I am confident saying these are some of the best one piece mounts currently available. Accessories

Its been asked for, I dont think there are any immediate plans at the moment though.

Walk it off similar to how you install it. The hardware is retained by a snap ring to allow you to push it back off the tapers. So just give each screw a rotation or so, alternating back and forth, until it walks off the cap. Be sure to not just run one screw out by itself.

The low diving board for the Area 419 mounts will be available soon (next week maybe) and gives a little more room behind the turret. When designing the mounting interface there were some compromises we had to make, but the result of that compromise is a diving board as rigid or better than...

No bedding, just dropped it in, with several chassis and different actions, all have shot very well.

Dropped it in, torqued it down, shot it. Shoots good.

(y)

Ryan did a great job with this match. The CoF was fantastic and a step forward from last year. Its unfortunate that miscommunication caused a bit of a mess on Saturday evening but Ryan made the right decisions to get things wrapped up well on Sunday. This is one of my favorite matches of the...

10/10, would recommend

I havent tried the update to the retail app but the beta app was solid

When we set out to make the perfect scope mount, we knew what we needed to make something that was reliable and consistent at a degree you won’t find anywhere else on the market. This led us down a rabbit-hole, ultimately arriving on a process that gets you final-bore matched rings, with raw...

Yes the action needs to be cut for AW mags

AW are fine