Recent content by Painterbolt
- P
Suppressors Form 4 wait time
Not bad, especially considering my finger print cards were mailed in.- Painterbolt
- Post #11,475
- Forum: The Armory
- P
Suppressors Form 4 wait time
Have a form 4 that ATF just recieved my finger print cards for yesterday. My dealer has forms being approved in days and some that have been pending for months.- Painterbolt
- Post #11,466
- Forum: The Armory
- P
repeat load dev if adding a suppressor?
It all depends. I have an older yankee hill direct threat that moves my point of impact up about .6 and .2 to the right. Groups open up a little but not much. Just got a Maverick and my point of impact stays the same and groups don’t change at all.- Painterbolt
- Post #12
- Forum: Reloading Depot
- P
Post Your AMP Press Plots
Just a coating. Did some load development with Neo lube and tried without. Group size stayed the same just gained an extra 25fps. Wasn’t sure if that was normal- Painterbolt
- Post #106
- Forum: Reloading Depot
- P
Post Your AMP Press Plots
Anyone notice a decrease in velocity going from no lube to lube. I’m getting about a lose of 25fps.- Painterbolt
- Post #104
- Forum: Reloading Depot
- P
Suppressors Area 419 Maverick vs BOSS Chairman K
I have a Maverick waiting on a form 3 to my dealer. But plan on getting a boss and thunderbeast RR. Only thing I’m not sure of with the boss is the alignment method. From what I gather u use shims. With my ocd, muzzle device and shims are never perfect.- Painterbolt
- Post #2
- Forum: The Armory
- P
Accuracy International Picture Thread
Really liking the vision grip skins- Painterbolt
- Post #18,142
- Forum: Bolt Action Rifles
- P
12rnd Billet AW magazine for BR size cartridges from Gray Ops
My current mags are so damn temperamental. I can go 3 months without an issue and then all of a sudden I can’t feed a single round reliably. I have no issue spending this kind of money if it fixes my problem. I already ordered 2. Just reference I running a 6br in an AI.- Painterbolt
- Post #4
- Forum: Bolt Action Rifles
- P
SOLD Area 419 M-Series 6br Die
Die functions perfectly. Includes due ring, die removal tool and original case. Price is 375 shipped, buyer covers PayPal fees.- Painterbolt
- Thread
- Replies: 0
- Forum: Buy - Sell - Trade
- P
Post Your AMP Press Plots
aneal Dry tumble in corn cob Resize using area 419 die with .242 mandrel Dry tumble again in corn cob Run through my Henderson trimmer Then run a brush right before seating. I wish my seating pressure was lower but for whatever reason my 6br brass has always had a high seating pressure...- Painterbolt
- Post #85
- Forum: Reloading Depot
- P
Post Your AMP Press Plots
Only loaded 10 so pretty small sample size. 6br- Painterbolt
- Post #82
- Forum: Reloading Depot
- P
Post Your AMP Press Plots
I just started messing with Molly in the neck right before I seat a bullet. It seems to help with consistency. Also lowered seating pressure by close to 10lbs.- Painterbolt
- Post #2
- Forum: Reloading Depot
- P
SOLD Longshot LR-3 Gen 3 Long Range 2 Mile +UHD Target Camera
Purchased February 1st of 2024. Camera functions perfectly and looks as new. Includes the bullet proof warranty as well. Price is $700 shipped, buyer covers PayPal fees.- Painterbolt
- Thread
- Replies: 2
- Forum: Buy - Sell - Trade