Recent content by Pakratt99

Sold

Yes, this is all still available.

Friday Bump, if I'm off base on any of the prices then let me know.

Looking to sell a Foundation Exodus and Ingenuity Gunworks rail. Foundation is cutout for a Rem 700 inlet on top and KMW Bottom metal. Color is Natural and the setup was a safe queen, built it up and just never used it. Ingenuity rail will mount right up to this setup and is one of the slickest...

Sorry, this has been sold.

You're correct, it is a 34mm ring with a 30mm height; was in a hurry and wasn't clear.

Looking to find a new home for my Sphur SP-4001, One piece mount 0 MOA with 34mm rings and a 30mm height. Has been mounted but I can't find a mark on it, $370 to your door CONUS.

SPF

$85 to your door CONUS.

What Sheldon said, OBT captures the largest nodes and if you have good input data you tend to get great results out of it. I did OCW after the fact and found other use able nodes but they were not as big nor quite as good as those found with OBT.

Why are you assuming its the boat tail? What bullets and distances off the lands have you tried? If you have never tried a flat base, what makes you think that would fix your problem?

What's your process for annealing? Also any chance after you had one load stiff, before forcing it you pulled the case and knocked the head out to take measurements? I've seen something similar with a friend who was annealing by eye with a MAP torch and made the necks WAY too soft so they turned...

Link to the article isn't working for me, but I'm assuming its not a single variable situation. If you took two identical models of rifle but one has a bad crown and the other a perfect one you can still have other variables in play. This is the reason you hear some people say they have a "good"...

If you take 20 identical rifles, 10 with perfect crowns and the other 10 with crown issues the perfect lot as a group will always outshoot the issue group. When you isolate it to a 1v1 ratio if you say took the worst shooting perfect crown in comparison to the best crown issue rifle you might...

I'm using the 110's and am REALLY impressed with them out of a Dasher in a 24" barrel. I'm shooting a Brux at 1:7.5 but know of people getting them to stabilize out of as slow as an 1:8. Best I've seen is a 5-shot at @.125 shooting 100yd and with the BC they have it should be an easy head to...