Recent content by pyrofx

Any idea if the mags fit the Springfield trainers?

Yes . I was. it is a shitty design. They admitted it , and some does every tier 1 smith. It digs in and creates a bur.

Did they fix the extraction ramp. Mine sucks. Sharp bolt piece , soft steep on action. Digs in like a bitch.

Chad . Thank you and Eric. Artemis shot the lights out when I cold bored the reassembly at 480 yards. Also. Parkinson's can be good for the significant other. Nice quiet nights on the front porch with you hand in her lap. Greg

I need the 9mm set. PM inbound

Just damn. ........ I didn't know there was a grand kid. I remember when Timmy was born. Shit Im getting old. Kenny and Peg must be happy but exhausted. Greg

I'll take the amax greg

Yes . Call LRI . Builds a great stick. He is not a fur trapper. Lcpl. Dixon and a buddy tried trapping ground squirrels at Camp Pendleton. End results were not what was expected, other than an awesome story

Are you getting your pm's. Need 500 prep

6 and primer falls out greg

Hell I spent this much buying chinese atlas copies and putting the importers out of business. ( nailed 6 of them now ) Put me in for one . Then I can help Frank with the hot chick overages. Greg

Back it. Out and run the correct tap in it

Neither..... barefoot .:rolleyes:

Had the problem with carbine gas system . Only way subs worked was with AA1680. Went to a pistol gas and cycles with almost any powder. If carbine , redrill barrel to pistol length and use an old gas block to cover the old hole. My port is .093 in dia. Greg

Dave at CH4D has small base dies for the 338. I found out the hard way when someone gave me a bunch of brass fired out of an AI. It would not chamber after sizing in 2 different dies. Small base cured the problem. As for extraction . Now I still do have to "bump" the last bit . But I blame that...