Recent content by Quietcro

@Millron good communication, shipped quickly, item packed well. Good to go.

Funds sent.

Does anyone make a 16.5mm scope rail for the T1x? I’m looking for a rail that bolts or clamps to the T1x 11mm rail which has a 16.5mm rail (T3x size) on top. I have a T3x spuhr mount that I want to utilize on the T1x in an MDT acc. I cannot find one anywhere. Any suggestions? Any members who...

That’s a picatinny base, not a 16.5 dovetail.

Does a 11mm dovetail (T1x) to 16.5mm dovetail (T3x) adapter rail exist? I have a T3x spuhr mount I would like to use.

Sorry for the late reply, but I did it on a regular ACC with a Dremel and some files. Lay the action in without the trigger group so you can mark the cuts. For the safety/trigger relief cut, get the dremel router attachment so you can adjust the depth of the cuts. The top edge of the chassis...

Gone

Big up for West Texas Ordinance. I have two Tikka actions with Switchlugs. I, like you, wanted one do-it-all rifle. After considering the ammo, time, and possible mechanical abuse of constantly changing the configurations, I went with two identical actions. I bought two tikka rifles, one...

PM sent

PM sent

Problem found. The neck bushing I received is the wrong size. Those rounds had basically no neck tension. I just pulled apart the second ladder I built. Trust but verify. Measure twice, cut once. Thanks for all the input.

Edited.

This is my first set of handloads and my first ladder test. This is a hunting only load. All screws torqued before firing and verified tight after. Point of aim is center dot. 300yd target. Prone with TBAC bipod and rear bag. Lateral correction between shots 1&2. My question: the rounds...

Sold. Off Hide.

Still available.