Recent content by randy86314
-
R
22-250 small base sizing die
I am late for the train, again. Before you chamber your rifle, why do you think you will need a small base die? My reamers are minimum SAAMI spec, and standard dies work fine. Before you order the chamber, check the dimens. So called "match" chamber might be undersized without benefit. The only...- randy86314
- Post #14
- Forum: Reloading Depot
-
R
progressive lenses for rifle scope
Thanks, everybody- randy86314
- Post #6
- Forum: Observation & Sighting Devices
-
R
progressive lenses for rifle scope
When I shoot a scoped rifle off the bench, I "look" thru the upper left corner of my right lens, which doesn't have much or good correction of my astigmatism. If I have a single vision lens made, which part of the prescription should I use? Distance? Reading? In between? Optometrists haven't...- randy86314
- Thread
- Replies: 7
- Forum: Observation & Sighting Devices
-
R
Neck doughnuts and Redding Bushing dies......help please
Iffen the bushing is sizing the neck only 1/3, then something is not right. I searched this topic because I just noticed a small donut is created on necks of my 250 Sav AI by incomplete neck sizing, about 0.015" short. Neck turning and expander ball? For me the ideal setup is to coordinate neck...- randy86314
- Post #20
- Forum: Reloading Depot
-
R
Gunsmithing Help: AR15 Bolt not locking back on last round
Re: Help: AR15 Bolt not locking back on last round I joined the group so that I could jump into this briar patch. A neighbor asked me to fix his M4 by CMMG, which was not locking after the last round in the magazine. In addition to my internet search, which brought me here, I perused my books...- randy86314
- Post #33
- Forum: The Armory
