Recent content by Robdaniels

Thanks a lot. I thought I could, just wanted to be sure. Nice looking 10/22 there.

I want to Cerakote a 10 22 aluminum receiver. Can I put that in the oven? Anybody done this before with good results? I only have the oven cure. Thanks

True, I can always remove it, but I am going to free float from the recoil on out. More yes than nos on the subject. Plus side is I can always add it too. Thanks guys!

I am getting really to install pillars and then full action bed a wood stock my Remington 700 270 WSM.. I have had B&C stocks, to much flex, and have a HS stock now on a Ruger 300 Win Mag, but another HS stock just isn't in my budget at this time. Just retried this year and still waiting to...

I am getting ready to install pillars and full action bed a Rem 700. At what point do you measure for the pillars and how? Thanks

What do most guys doing this as a side line use as a paint booth?

Thanks for all the input folks. Looks like I save up a bit and bite the bullet.

Thank you, I am also looking at a Warwick 878. It looks better than the Ingersoll Rand 200G. Oh, I forgot. I have been reading the forum for quite some time but this is my first post. I am getting into spraying gun finishes here on the Oregon coast. I have a blast cabinet, an oven and a paint...

I know this has been beat to death, but I have a question. I try not to get the cheapest and I stay away from the best because of my limited budget, so I usually buy in the middle of the road somewhere that doesn't hurt my pocket so much. Has anyone used an Ingersoll Rand 200G Edge Series .8...