Recent content by SAPPER77
-
REM700 XCR BOTTOM RAIL / BIPOD HELP
Hi all, I have a GG&G bipod that I like a lot, and want to mount it to my XCR... problem being that my bipod requires a picatinny rail. I see several "half" rails and "short" rails for sale including a couple of promising ones shown below. I am currently in Afghanistan and therefore can't...- SAPPER77
- Thread
- Replies: 0
- Forum: Bolt Action Rifles
-
Rifle Scopes REM700 XCR with NXS 5.5-22X50 - Which NF Rings?
Re: REM700 XCR with NXS 5.5-22X50 - Which NF Rings? Thanks again for all the replies. Has anyone else experienced the bolt handle contact with the butler creek covers using the .885 rings? It looks like the low rings are fine for the front/objective end of the scope, but jamiebob has had...- SAPPER77
- Post #9
- Forum: Observation & Sighting Devices
-
Rifle Scopes REM700 XCR with NXS 5.5-22X50 - Which NF Rings?
Re: REM700 XCR with NXS 5.5-22X50 - Which NF Rings? Thanks for the quick reply. I guess a little more than 1/16" isn't much higher to gain the full use of my scope so it looks like 1" rings are the answer unless anyone else has a work-around for the bolt handle contact on the butler creek...- SAPPER77
- Post #3
- Forum: Observation & Sighting Devices
-
Rifle Scopes REM700 XCR with NXS 5.5-22X50 - Which NF Rings?
Hi All, Looking for some help from someone with this setup or someone in the know. I have an XCR .308 20" and I'm ordering a Nightforce NXS 5.5-22X50 NPR2 for it in the next few days after a few months deciding on the scope setup. I am currently in Afghanistan so I can't measure and don't have...- SAPPER77
- Thread
- Replies: 8
- Forum: Observation & Sighting Devices
