Re: 455/ Lilja range report(100yd update)
Drops right in,
If you get the varmint Taper contour, there is little modification to the 455 american stock.
If you go with the straight bull barrel you need to open up the stock a little more, but its not bad.
If you get a 455 Varmint, there...
Re: Got my AICS airsoft stock today, Wells G96 folder
In the same boat as you, Only I have the stock coming with the rifle in hand. I'd like to see what you come up with as far as action alignment and floating/supporting the barrel.
Mine should be here by the end of the week or early next...
Re: 455/ Lilja range report(100yd update)
I did not have too much time with it last night. I took the barreled action out, I am going to need to open of the stock a tiny bit more on the right side.
When I put it back together it seemed to cycle the action much easier.
I will have to examine...
Re: 455/ Lilja range report(100yd update)
I see.
Mine is closing tight WITHOUT a round in. I don't think the chamber should have anything to do with it. I'll take another look tonight.
Thanks Guys
Re: 455/ Lilja range report(100yd update)
American like yours. Dowel rod with sand paper opened it up quickly and easily. I'll be working on the barrel channel to support it as well.
Does your bolt close hard?
Re: 455/ Lilja range report(100yd update)
Sounds good. They will be next on my list. I am looking for the best hunting ammo out of this rig, out to 100 yds.
Another question. Does anyone notice the bolt was hard to close even without a round in? Thinking about lapping around the bolt...
Re: 455/ Lilja range report(100yd update)
I couldn't resist. Got the lilja this week. Thanks to Ao6 and Jaia for making it utterly impossible to pass up.
I hope A06 doesn't mind a little thread high jacking. I had a little time at the range.
This was at 50. 5 shots. top one was not in...
Re: CZ 455 Pillars
Thanks A06,
I was thinking about going with a Lilja, but wanted the straight pipe, not the varmint taper. FINALLY someone else posted one on here! More pics, especially when you shoot it.
Re: Stiller M700 Short DBM install/review
Thanks for posting this. I was wondering how much modification was needed for this system. Looks like a manners inlet for standard BDL will only need a little sanding to make it work.
Re: Tubb's bore lapping bullets
I just saw these the other day. I was wondering the same thing.
Is it worth it on a factory barrel? I am shooting sub MOA, but always looking for anything to improve it.
Thanks
Re: Warning about new marlin firearms!
Unfortunately I had a similar experience with their quality.
http://www.snipershide.com/forum/ubbthre...872#Post2811872
It is a shame as I do have a marlin 917 that I like.
I hope they get these issues fixed.