tomme boy's latest activity
-
tomme boy replied to the thread AR-10 is chewing up my brass.If you get the high pressure bolt make sure to get the firing pin to match. -
tomme boy replied to the thread AR-10 is chewing up my brass.Hornady brass I find at the range always looks like this out of a AR10. The stuff is crap.
-
tomme boy replied to the thread AR-10 is chewing up my brass.just because it throws the brass at 3-4 does not mean it is gassed properly. Turn down the gass and get a heavier buffer. But you may...
-
tomme boy replied to the thread AAC ammo grenading rifles.These are splitting because of the case drawing operation had a problem. The brass gets thin on one side and this happens. It happens to...
-
Looking to replace the barrel on my cz. Looking at some of the cheaper barrels. I don't see a whole lot about these barrels. All I can...
-
did my Faux K98 today , pretty busy week so doubtful i will get to sight it in this week , the scope and rings separate very smooth and...
-
tomme boy replied to the thread What did you do in the reloading room today?.Sized and swaged a 5 gal bucket of 9mm. My arm is killing me.
-
tomme boy replied to the thread AAC ammo grenading rifles.Someone should be talking to Hornady if the bullets are stripping the jacket. Only time it usually does this is on a really low fps...
-
tomme boy replied to the thread Weird Eley Match Lot#.Lot #'s stay the same as long s the exact same lots of components making the lot are the same. They are not going to change lot#'s for a...
-
tomme boy replied to the thread Weird Eley Match Lot#.Any of you guys work in a production environment? Just because it is the same lot # means nothing if the run was started on one shift...
-
tomme boy replied to the thread Weird Eley Match Lot#.Yah I would be sending that crap back
-
tomme boy replied to the thread Pistol Reloading Issue I cant figure out.If it is blazer brass you are using or the ones you are having trouble with, that is the problem. The brass is thinner and it needs a...
