Recent content by TSFR
-
T
Rifle Scopes Is touching to close, even if its 1/32 of an inch?
Re: Is touching to close, even if its 1/32 of an inch? Nobody even commented on how well it came out, how magnificently close it was to the barrel without touching and the obvious amount of daylight....geesh, tough room lol Seriously, thanks again for all the advice, laughs and help - Jeff- TSFR
- Post #28
- Forum: Observation & Sighting Devices
-
T
Rifle Scopes Is touching to close, even if its 1/32 of an inch?
Re: Is touching to close, even if its 1/32 of an inch? For the record: NO Scope was harmed in any way durning the completion of this project- TSFR
- Post #24
- Forum: Observation & Sighting Devices
-
T
Rifle Scopes Is touching to close, even if its 1/32 of an inch?
Re: Is touching to close, even if its 1/32 of an inch? So the channel locks did the trick! Dont know why I didnt think of that in the first place. Apparently I didnt make my situation 100% clear and I appologize for the confusion. The new mount (pictured below)is a 1 peice Nightforce 20...- TSFR
- Post #22
- Forum: Observation & Sighting Devices
-
T
Rifle Scopes Is touching to close, even if its 1/32 of an inch?
Re: Is touching to close, even if its 1/32 of an inch? <div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: jaaron11</div><div class="ubbcode-body">Are you planning on putting lens caps on it? If so, no amount of fidgeting forward or backward will give you the...- TSFR
- Post #6
- Forum: Observation & Sighting Devices
-
T
Rifle Scopes Is touching to close, even if its 1/32 of an inch?
Re: Is touching to close, even if its 1/32 of an inch? Thanks for the insight. The whole reason for switching the mounting rail in the first place was when the cheek rest was properly set.....I couldnt get the bolt out because it was set to high and bumped against it. The lower mount allows...- TSFR
- Post #3
- Forum: Observation & Sighting Devices
-
T
Rifle Scopes Is touching to close, even if its 1/32 of an inch?
Hello everyone, I have a remington 700 that I have done some work to which includes finally getting a decent scope (Sightron SIII) and also a Nightforce 1 peice rail/ring mount. I got the low mount 20 MOA adjustment and its literally a hair away from being perfect. The VERY tip of the scope...- TSFR
- Thread
- Replies: 32
- Forum: Observation & Sighting Devices
