Recent content by VGW 22

Colt1860, Paul Parrott here. Sorry for the slow reply as I am not on here much since we are so busy but one of the moderators was kind enough to reach out on your behalf and let me know your troubles. We will absolutely do up a 16.5" in MTU for you in .22 LR. I apologize for the response you...

Absolutely my pleasure. Sorry for the confusion and keep us posted on how it goes with the heavier spring. We improve by getting feedback from our amazing customers and we really do listen. All the best.

What Mike is showing is our repeater firing pin and its evolution from the original 'chisel' tip. He is in a constant state of R&D on all our products but our SS Firing pin is working as intended, not that he might not continue to fiddle with it as he always does on everything. Are you...

Just for clarification everyone, the firing pin Mike posted with the ammo showing indentations, is a Repeater firing pin, not the single shot which has a 6 o'clock pin position. Our SS Firing pin started in this configuration and during Mikes exhaustive R&D, went through several iterations to...

We run Mikes "Ravage" chamber. It is good with 95% of the ammo out there but it is tight. As few rounds as you have through it at this point, i would be surprised if it was dirty. I suspect the CCI SV has a dimensional issue though it gets shot fairly often by our customers. I have...

I posted some suggestions above, but dont hesitate to call me and we'll get ya squared away. Paul Parrott CEO

Call me Sir and we'll fix you right up. Paul Parrott CEO

Hi Gents, Paul Parrott here. We have had a few complaints of feeding issues with some of the flat point ammo out there. Mike did design the mag some time ago around the more common round nose .22lr but...we want it to work and feed for everyone. Its not hard with any .22 ammo, to get 'rim...