SOLD Tikka TAC A1 Chassis and CTR mags

david walter

david walter

Insightful commentator
Supporter
Full Member
Minuteman
Supporter
Jul 22, 2007
3,542
3,410
Out west, but not too far west
#1
It's definitely used but not abused. Bought from another member, decided to go in a different direction.

MLOK slots have a good amount of wear / marring due to a DIY weight kit that's since been removed.

I'm thinking $600 with the three 308/6.5 Creedmoor/6mm Creedmoor CTR mags shipped sounds fair, or $475 without?

Optic rail and hardware included.

Rail is configured for a T3X, but can be made to work with a T3. Difference is in the hole in the receiver top on a T3X allows included rail recoil pins to work.

196845.jpg

196846.jpg

196847.jpg

196848.jpg
 
Last edited:
#3
The recoil pins are on the rail, and the T3 lacks the holes for the pins to fit down into.

The T3X has two additional holes on top of the action to accommodate these pins.

On a T3, you can tap the pins up into the rail, and just use the 4 screws for the rail.
 
#6
If you tap the pins up into the rail, would they sit below the top rail surface? just in case you are putting the ring/mount in those spots...
 
#7
Nevermind the question. I see the rail is thicker than the length of the pins, so it would be OK. But once you do that, would you be able to pull the pins back out?
 
You must log in or register to reply here.

Similar threads

Chopping Broccoli
SOLD KRG Bravo - Tikka T3X for CTR Mags
Replies
2
Views
274
Chopping Broccoli
Chopping Broccoli
W
SOLD Tikka Tac A1 Chassis + 3x Mags
Replies
10
Views
503
ArmchairOperator
ArmchairOperator
wilsoN_
SOLD Tikka Tac A1 chassis
Replies
2
Views
453
wilsoN_
wilsoN_
A
Left Hand Sale Tikka Tac A1 Chassis LH w/Area 419 extras
Replies
1
Views
348
awpk03s
A
mccarthy
SOLD Tikka T3 Tac A1 6.5CM
Replies
8
Views
1K
mccarthy
mccarthy
Top Bottom
Back
Home
Forums
Merch
Alerts