I went to use my autotrickler v4 this morning and all was well until I tried dispensing charges. When I try to dispense charges it will work for a spot second and then show "Lb" on the screen. From what I can tell it stands for low battery and is usually an issue with the adaptor. I swapped the adaptor out with a friend's and it's doing the same thing. I put a picture of the screen below.
It goes through calibration just fine, dispensing normally. It will even work dispensing the load if I change the scale to grams instead of grains. It seems every function works fine except dispensing loads in grains.
Any one have any suggestions?
It goes through calibration just fine, dispensing normally. It will even work dispensing the load if I change the scale to grams instead of grains. It seems every function works fine except dispensing loads in grains.
Any one have any suggestions?
