Elcan Help

I’m more curious why you’d want to take it apart.

I know nothing about the Elcan, but from what I see there - I'd clear carefully and contentiously without further disassembly.

Blow it out with compressed air, or use some pipe cleaners. Not sure I’d take it apart

Honestly, I wouldn't mess with it. What you are talking about doing is essentially mucking with what is the erector assembly as it were, on an Elcan.

I'm sure you're aware that the Elcan's base is spring loaded. You can lift up on the rear end of the scope body to give you a little room. I'd drizzle some cleaner in there, let it soak and then blow it out with air. Elcan's can take a lot more abuse than hunting in Texas.

As far as applying compressed air goes, I wouldn't go shooting a high pressure stream of air at any sealed seams.

Personally, I'd just dunk the whole thing in a bucket with Dawn dish detergent, work the spring action on the body a few times and rinse it off.