I see that mile high has some berger 6.5 CM 153.5 gr factory ammo in stock and I would like to try it. I have a howa 1500 with a 1:8 twist shoots 140s really well do you guys think it would be able to stabilize a 153.5 grain bullet?
- Thread starter Islas82
- Start date
I will be founding out soon enough I just purchased some lol, I ran my specs on their “twist rate” calculator on the Berger website and it seem like it should run fine. We’ll see.
Berger’s calculator shows it marginally stable in 1:8 Until you’re around 5k elevation.
1:7.5 is stable in all conditions.
So, the answer is.......maybe.
1:7.5 is stable in all conditions.
So, the answer is.......maybe.
Though berger also knows most everyone is running a 1:8. So I doubt they would make factory ammo that isn’t stable in most barrels.
This is what am getting according to my data. Temperature may vary since its starting to cool down. 
Has anyone used the Berger factory load? (153.5gr)
Any issues? Do they fit in standard AICS mags?
Thanks!
Any issues? Do they fit in standard AICS mags?
Thanks!
If you can cycle an overall projectile to 2.950 get them. Im working with a limit on my mag to about 2.815 and my bullet jump is approx.180"
Im gonna try it again this spring- see if i can find an accuracy nodeplaying with bto with jumping to see if they'll work. If not- hornady 140 match or smk on deck
Im gonna try it again this spring- see if i can find an accuracy nodeplaying with bto with jumping to see if they'll work. If not- hornady 140 match or smk on deck
Last edited:
Similar threads
