Search results

I’ve been reloading a long time for many rifles and cartridges. I’ve got a jug of IMR 4166 I’m trying to burn up in 308. Has anyone had luck with any combination they feel like sharing?

Today, I went to the range to see if I could find a primer that will work with an AI that has a larger firing pin. The primers tested left to right were Winchester #41, Winchester SR, Federal 205, CCI 450, CCI BR-4, and Remington 7.5 BR. The load for each is 28.3 of IMR 4166, Norma brass, and...

Does anyone know the length for a minimum SAAMI headspace? Thank you.

What are people using? Every one of these I’ve seen has been an absolute hammer.

During a shortage, a shooter can wind up unprepared. Or, occasionally, components we don’t typically use can fall into our laps. I’ve experienced both. What are we to do with these new supplies? Obviously, we should use them or pay them forward. I had wound up with several pounds of AA2495...

I load for several buddies. One of them is coming to the end of his FGMM pile. He asked if I could duplicate Hornady TAP with the 168 ELD. A couple of years back I had loaded him a ladder with 168 ELDs and Varget. I figured I’m part way there already. He’s always had good luck with Reloader...

Today, I went to the range to check the POI shift that occurs when I swap barrels on my AI. I figured I’d also test the POI shift that occurs after attaching my direct thread suppressor. I set up two targets at 100 yards. On the first is a central POA. On the second, there are numerous POAs...

I’ve got an Impact 737 set up as a 6.5 Creedmoor. Recently, I bought a 223 bolt, barrel, and a 308 barrel. I went to my local range with a viper barrel vise, two c clamps, action and torque wrench. I confirmed zero. Then, I’d switch barrels and plot the impacts. After swapping barrels back...

Are these specific inlets backwards compatible?

My direct thread suppressor keeps coming loose every few shots. How do you guys avoid this? I tighten it, but I can tell by my groupings when it loosens.

I’m looking for a suppressor cover for a TSC Outrider. What’s working well for you guys?

Does anyone have any good 223 bolt gun loads for more compact barrels? I’ve checked the tacked thread, but I didn’t find much for shorties. TIA

I’ve seen it posted that BR2s and CCI LR primers are substitutable. I’ve also seen that LC LR weighs basically the same as Lapua brass in 308. My experience confirms both of these.

Has anyone found any good loads for these bullets?

I missed the threads about people having trouble with Nosler brass. I loaded a couple of ladders and barrel conditioning rounds to shoot today. I was using 147 ELDs, Nosler cases, and CCI LRP. OAL was 2.875”. It was 97 degrees today. I used H4350 and Re16. I generally shoot a...

I’m gathering pieces to assemble a 300 PRC. I’m going to need to need a stock or chassis. Any recommendations or sources?

I like the way the AI takes pre-fit barrels. What other receivers take pre-fits? How do you like them?

Is there a 243 load thread? I’ve had success with 105s and H4350. What do you guys like?

That’s a 168, 169, and a 175. I’ve had a chance to shoot these. Sierra has done well. I’m using 44.4 grains of Varget and getting around 2,750.

Do you run a ladder test, shoot groups, or test length first? How do you build your best ammo?