easy

I plan to use my state welfare check in Oct if it contains large enough coin for a suppressor for my GAP 308 and trying to get INTEL. Is it really that easy? I send money with my info and the suppressor I want to Maj Malfunction, paper work is done by them, they send the muffler to my class 3...

I am attempting to reload .223 flat based bullets ( varmint grenade 55gr and speer 70gr ). I have loaded several thousand NBT with the beveled base, but the flat based bullets will not go into the case mouth. I am using a RCBS press with RCBS dies. I have read everything I have, the RCBS...

OK, so I am getting ready to start a build. I have settled on a Lawton 8000 repeater and a Lawton barrel. I want to do a 375 setup and have searched and researched for weeks. It is my understanding that projos and twists are very much up in the air right now. So, here is what I don't know: 1...

Part 1 in my series....:D 2 ways to make a mag release extension for an Anschutz 64, I'm sure many other .22's could be done this way, also. 2 ways because some of you won't want to drill a hole in your new $1000 rifle, at least until you get a few scratches on it, like me. First the no...

i just moved my nightforce 8 x 32 nxs from my 6.5 x 47 to my sako trg 42 in 338LM. the scope was sighted in on the 6.5 x 47 with a 100 yard zero. the 6.5 x 47 has a 20 moa base on it. the ballistic table for the load i was using says at 100 yards there was 2.47 inches of bullet drop with the 6.5...