remove

Have a jewell trigger with the rem style bolt release. Got a new action with a side bolt release. I know what happens when taking rem triggers apart, but would hate for this jewell to go "boing" when taking out the two large pivot pins, to remove the bolt release deal. Anyone ever successfully...

What is the best way to remove old bedding compound? Will rebarrel and switch over to badger DBM setup and want to make sure the pillars/bedding is correct. Thanks

I am trying to take my badger stabilizer off and replace it with a DD lite rail. after I removed the screws that hold the badger on the triangular barrel guide part. how do i get that triangular part off away from the gas tube and barrel. I am afraid I dont know too muach about these.

Hi : want to remove a 17 barrel and replace with the 22 mag barrel I got with the purchase.. it is too tight to remove by hand... advice is needed.... thanks dan kennison

I shoot moly and always have. Lately ive been talking and reading and apparently I clean my rifle too often and too intensely. So my question is if Ive recently cleaned pretty much to the metal then fired 50 rounds of moly coated rounds, when and how should I next clean my rifle so as to leave...

I am interested in purchasing a rifle from another private party but there is a modification that I would need on it and wanted to see how difficult it might be to swap the bottom metal. The rifle is a KMW 308 rifle with a McMillan A5 stock. It has a Surgeon tactical action and Remington...

Well, I just got my EGW base and removed the old 2 piece base. It apperas there is some sort of bedding compound put there by the guys at Dick's when they mounted the scope there. I tried removing it with Acetone and Goo Off, but they didn't work. So, I scraped it off and got most it off, but...

I am thinking about getting one of those new Remington R-25 (DPMS) .308 gas guns. I guess the Remington lawyers think they look less evil if they are dipped in that camo film crap. I plan on Duracoating the rifle. I will replace the stock, grip and handguards, so I am not worried about them...

hey guys dumb question but im a noob. How do you remove the recoil pad (or sholder pad) on a hs precesion pss stock? There are no screw holes or anything. am i just missing something? Thanks

I've got a Lee Anniversary kit on the way and will be reloading primarily once-fired Lake City brass. What, exactly, do I need to do to the crimped in primer?

I've got a bunch of 5.56 cases that need to be de-crimped. I figure the best way is with the Dillon Primer Pocket swager but I'm not ready to spend that much yet. RCBS makes a die that swages the primer pocket, anyone have any experience with it? Is it easy, hard slow ...? Also Forster...

I have some bases on an action I want removed. I don't know if they were installed with lock-tite or just natures rust that has prevented the screws from coming undone. While trying to remove the screws, they have become stripped. These were alan #8 screws. Any ideas on how to go about...