Gunsmithing 17S mounts dimensions

[Lukas Koukal]

Anybody using a 17S mount for any purpose (with an Atlas bipod, different accessories)..?

Like this one: Accu-Shot Product Catalog – Monopods – Bipods - Accessories

I´d need to know the interface dimensions if anybody cares to help, that is the rail width and screw holes spacing.

Thanks a lot in advance... LK

 

[338_Lapua]

Edit: Seems like my information was wrong, please disregard. See below for correct info.

This is an old thread but I think this is correct. Wouldn't bet my life on it. Maybe someone else could verify.

9.2mm/0.36" wide
2.7mm/0.10" deep
2 inch spacing between holes
5.6mm/0.22 inch hole diameter or sometimes 3/8 inch, usually supports #10/32 screws

 

[jabonra]

Found on the zbolt site

 

[338_Lapua]

Found on the zbolt site

@jabonra you have some next level Googlz skillz! I couldn't find 'nuffin 'cept this, which is apparently wrong:

 

[338_Lapua]

@jabonra I'm looking for my source but I thought somewhere it said the standard was 2" between the holes, but it's actually 1.1" ? Do you actually have a 17S clamp somewhere and can verify?

 

[jabonra]

I probably have a clamp or the aics spigot laying around I can measure tomorrow if no one else verifies by then!

Edit: here's the b&t rail for the spigot saying the hole spacing is 1.1 as well

https://accu-shot.com/shop/accessories-official-manufacturer/bt20b-aais-bottom-rail/

"It attaches to the bottom of the BT19 AAIS via blind threaded 10/32 holes and has a two hole pattern of 1.100″ (see third image)."

 

[338_Lapua]

I probably have a clamp or the aics spigot laying around I can measure tomorrow if no one else verifies by then!

Edit: here's the b&t rail for the spigot saying the hole spacing is 1.1 as well

https://accu-shot.com/shop/accessories-official-manufacturer/bt20b-aais-bottom-rail/

"It attaches to the bottom of the BT19 AAIS via blind threaded 10/32 holes and has a two hole pattern of 1.100″ (see third image)."

Much appreciated!