22-250 neck thickness

[7P's]

Request a little assistance. If anyone has new Lapua 22-250 brass could you measure a couple neck thicknesses with a ball mike and post up? Thank you in advance.

 

[Nodakplowboy]

Here you go. Lot #2223217, purchased 10/18, zero prep, right out the box. Measured 3 cases every 90 degrees using the below setup. Results:

High- .0146"
Low- .0140"
Avg- .0143"
+/- .0003" is pretty good brass. Hope this helps.

 

[7P's]

Thank you very much, greatly appreciated.