I'm working up an elr load and possibly a long range hunting load. It's a 28in 300norma shooting the 225gr eldm. The barrel is fast, brass and powder are allowing for a very good load at approx 3100fps. I know it's not necessary, let's not debate that. The question on hand is whether or not the 225 will survive at that speed. I've personally seen the 230gr atip come apart at at far less speed, so I'm wary. I want the performance that the cartridge is capable of, and that bullet gives it at that speed. Has anyone run the 225 that fast for long?
225 eldm elr load durability
- Thread starter 86alaskan
- Start date
Bullets coming apart is more about RPM, what is the twist on that barrel?
Bullet RPM = MV X 720/Twist Rate
You are looking 248k RPM. Should be safe but you could contact Hornady about the safe RPM of that bullets the a tips seem to blow up around 267 when the barrel gets a bit dirty.
You are looking 248k RPM. Should be safe but you could contact Hornady about the safe RPM of that bullets the a tips seem to blow up around 267 when the barrel gets a bit dirty.
Why Hornady projectiles vs Berger? Even in my little 300PRC I’ve gone to 245 Bergers. You would be able to push them much fast that I can. I find the Bergers very consistent.
245 Bergers were nearly impossible to get for a long while there, Hornady's stayed available the whole time. I stocked up on A-tips at that time.
I'll prob go back to Bergers after if they are available.
Similar threads
