Well I finally decided to try the 208,s with my 06. Here is some data along with the pic of the groups. all where five shot but the bottom one, that is only two, I followed up with 3 more when I returned, but I did not snap a pic then I was in a hurry. I would like to thank Montana Marine, I stole his data
I use a CHRONY yes a CHRONY
The top group was 185 VLDS
The next one down was 60gr of RE/22
2816
2798
2783
errr
2808
Middle one was 60.5gr of RE/22
2821
2822
2805
2821
2813
The last one was 61.0gr of RE/22
2745
2752
2911
2895
2902 The last three were shot a hour and a half later temp started at 87degrees, it was close to 100 by the last three. The last three were all touching I wish I would of took the picture because it was sic The only sign of pressure was when it was almost 100 on the last 3 of the 61grs, just a little flattening of the primer not a ton, bolt was super easy to open. I hope this helps anyone wanting to do the 208's in a 06, I don't know if i believe my speeds or not I am going to try again later this week unless I find work.
The rifle was a ITD built 22.5 MTU contour, I will try to get a pic up later, this unemployment is tiring and I need a nap
I use a CHRONY yes a CHRONY
The top group was 185 VLDS
The next one down was 60gr of RE/22
2816
2798
2783
errr
2808
Middle one was 60.5gr of RE/22
2821
2822
2805
2821
2813
The last one was 61.0gr of RE/22
2745
2752
2911
2895
2902 The last three were shot a hour and a half later temp started at 87degrees, it was close to 100 by the last three. The last three were all touching I wish I would of took the picture because it was sic
The rifle was a ITD built 22.5 MTU contour, I will try to get a pic up later, this unemployment is tiring and I need a nap