WTB 300 prc dies

[Axel314]

Looking for a set of 300 prc dies. Thanks

 

[Axel314]

Ttt

 

[davethedog]

I have a RCBS match micrometer seating die

 

[Axel314]

U no if 230 a tip will seat with the stem it has.

 

[davethedog]

I have some at home so I'll check at lunch. Its a pretty deep stem so I doubt there will be an issue. Worst case you can lap it with some valve compound - that's what I did with my redding set and it worked. Also, FWIW, redding seating stems fit in the die which was very convenient for me because I have several redding stems for different projectiles - I am mostly shooting berger 220 LRHT with good results but I have some test 230 A-Tip rounds loaded up to test today.

 

[Axel314]

Yea im gonna run 230 a tips. My rifle got here and havnt loaded for it yet. I found a hornady set and the 230 s tips wont fit in the stem. Was gonna drill it deeper

 

[davethedog]

Yea im gonna run 230 a tips. My rifle got here and havnt loaded for it yet. I found a hornady set and the 230 s tips wont fit in the stem. Was gonna drill it deeper

I find that's what you've got to do with almost all ELDs. There's just no good profile for all projectiles that wont leave a ring unless you grind it. Never bothered me though. I chuck up a sacrificial bullet to grind out the profile then polish with a dremel and some flitz. Zero runout and no ring.

 

[DAVETOOLEY]

I have two new sets of Hornady 30-375 dies. I had those made prior to the name change to 300 PRC.

 

[davethedog]

U no if 230 a tip will seat with the stem it has.

They seat nice with no ring or runout so long as your brass is in good shape.