Was planning on buying a 300WM but put money down on a 6.5 creedmoor instead so the supplies I have are on the block!
RCBS 300 Win Mag Full length dies (Part # 15301 a few uses but basically like new)
Lee Factory Crimp die
Ammo if you are local for FTF meeting (Atlanta GA area):
Remington 150gr Coreloct- 5 rounds
Brass (~120 pieces):
Remington/RP-
box of 20 new brass with primers installed (not sure what primer, they were like this when I got them, older box)
70 rounds of once fired RP brass. Most of it is prepped, but I would go thru them again to confirm- more than likely I have FL sized them, deprimed, trim, chamfer/deburr and then deburr the flash hole.
FC (Federal) brass- 20 pieces
Frontier brass- 8 pieces
misc (ann, RP nickel, etc)- 4 pieces
Will sell the whole lot for $100. RCBS die and factory crimp I will sell for $35. All of the brass for $75. I haven't checked prices in a while so if I'm off let me know. I can't ship primed brass or loaded ammo) but if you want I can deprime the brass and ship without the 5 loaded rounds. I can tumble in stainless (and prep all of the brass for a slight fee) if needed/wanted.
Will trade for 6.5 creedmoor bullets, brass, H4350 powder (if local in GA), or other caliber reloading supplies. I reload a lot of calibers, so try me. I can add cash if needed for the right trades (6.5CM stuff).
First "I'll take it" post or PM gets it. Or make me an offer! I have it posted locally as well.
RCBS 300 Win Mag Full length dies (Part # 15301 a few uses but basically like new)
Lee Factory Crimp die
Ammo if you are local for FTF meeting (Atlanta GA area):
Remington 150gr Coreloct- 5 rounds
Brass (~120 pieces):
Remington/RP-
box of 20 new brass with primers installed (not sure what primer, they were like this when I got them, older box)
70 rounds of once fired RP brass. Most of it is prepped, but I would go thru them again to confirm- more than likely I have FL sized them, deprimed, trim, chamfer/deburr and then deburr the flash hole.
FC (Federal) brass- 20 pieces
Frontier brass- 8 pieces
misc (ann, RP nickel, etc)- 4 pieces
Will sell the whole lot for $100. RCBS die and factory crimp I will sell for $35. All of the brass for $75. I haven't checked prices in a while so if I'm off let me know. I can't ship primed brass or loaded ammo) but if you want I can deprime the brass and ship without the 5 loaded rounds. I can tumble in stainless (and prep all of the brass for a slight fee) if needed/wanted.
Will trade for 6.5 creedmoor bullets, brass, H4350 powder (if local in GA), or other caliber reloading supplies. I reload a lot of calibers, so try me. I can add cash if needed for the right trades (6.5CM stuff).
First "I'll take it" post or PM gets it. Or make me an offer! I have it posted locally as well.
Attachments
Last edited:
