300PRC/ 338 Edge switch barrel build. Possible Charlie Tarac problem??

[KiloGolf]

Hey Snipers. Just picked up 1 of 2 orders of my chassis from MDT. I had KS Arms build me a 300 prc and 338 edge switch with a 60moa rail. After I installed it into the chassis, I think I'll have a hard time getting the line of sight into a Charlie Tarac. I don't have one as of yet... but this build was intended for a rail mounted one. Does anyone with experience shed some light or post a measurement from the top of the Pic rail to the center of the sight box of their Charlie Tarac?

I'll post better pictures momentarily, I think I'll have to get a 20moa rail and use my 20moa spuhr.

 

[KiloGolf]

 

[Taylorbok]

I'm not sure what you think the problem is going to be?

 

[KiloGolf]

With the Charlie on a QD mount, will its sight box be too high for my scope to see through it properly. I can't see my barrel or chassis looking through the scope as it is right now.

 

[Taylorbok]

You shouldn't have any problems at all

 

[KiloGolf]

You really think so? I am borrowing that spuhr mount (5001) from another rifle at the moment. I did some figuring and I'll order a taller mount (5002) that will give me 8mm rise for scope height. That way I think it will line up better, if that is an issue. But my Edge barrel is 2" longer than the PRC.

Thanks for your thoughts on the situation. Quite happy it should work the way it is.

 

[Taylorbok]

Ya I think you'll be mint with the way it is.