Suppressors 9mm suggestions
- Thread starter xdeano
- Start date
I'm a big fan of the Sico Omega 9K. It's small and it really does the job considering. I have a longer Mystic X and it's not a bad 9mm can at all (I bought it for 9mm use only really). Both can be used without the booster and with a 1/2-28 insert for use on rifles or pistols that don't require the booster.
Sico makes some nice stuff is always one to check out early on. Quality build, materials, workmanship, design and the ability to use other mfg.'s mounts is great.
Elite Iron makes pistol cans, I suspect they work great but I can't tell you much about them other than his large caliber rifle cans are some of the best made.
AAC has/had deplorable CS --that may be better with Remington, they did replace a mount I waited 2 years on with AAC in just a couple weeks right after taking over. Their materials are top notch (as are Sico's) but some of their mounts are trash, however, that's only with the rifle cans as far as I know.
Sico makes some nice stuff is always one to check out early on. Quality build, materials, workmanship, design and the ability to use other mfg.'s mounts is great.
Elite Iron makes pistol cans, I suspect they work great but I can't tell you much about them other than his large caliber rifle cans are some of the best made.
AAC has/had deplorable CS --that may be better with Remington, they did replace a mount I waited 2 years on with AAC in just a couple weeks right after taking over. Their materials are top notch (as are Sico's) but some of their mounts are trash, however, that's only with the rifle cans as far as I know.
Nope, they still suck. I bought a ranger 2 from them years ago. The threads were not concentric to any other part of the can, had horrible POI shifts and accuracy on everything I tested. It went back almost immediately, their "fix" was to cerakote it again so I couldn't see the shiny mark only 1/3 of the way around the rear and build up the cerakote thick as hell to try to get it to seat right.... It went back again a while later and they did the same fucking thing. I sent it back a third time and again they did the same fucking thing. I finally pitched a fit on barfcom where it would get the most traffic earlier this year and they basically finally admitted that they couldn't fix my can and that I can swap for a model that doesn't have the feature I bought this for (direct thread), and retails for less than I paid for mine... and I get to pay the tax stamp again. This was over the course of 5 years so they still haven't gotten their act together.
Fuck AAC.
FWIW I went with a Surefire Ryder 9 after hearing great feedback from users. It's still in ATF jail so I can't comment on performance personally.
Similar threads
