Advice Please: Bottom metal DBM

[corsair_001]

Rifle: Remington 700 mil-spec 5R 308, Harris bi-pod, SS scope in Burris rings on a seekins 20moa base. Shoot good for me now and I like the rifle.
I'm taking small steps, so keeping the factory stock for now. But quickly relaized that loading from the top with the base scope etc.. is a PITA. So now DBM. Candidates are Surgeon, Badger, and H-S. Can someone provide guidance: I.E. ease of installation, appearance, useability, or any other words of wisdom.
Regards

 

[DALLAS ROOTS]

Re: Advice Please: Bottom metal DBM

Just get a CDI dbm,they will inlet the stock for you. CDI will cost you less than the ones you listed. Here are some links.

www.cdiprecisiongunworks.com

http://www.snipershide.com/forum/ubbthreads.php?ubb=showflat&Number=1295359#Post1295359

 

[darrenk75b]

Re: Advice Please: Bottom metal DBM

The H-S is a drop-in unit. The others will require a gunsmith to install.

 

[jbell]

Re: Advice Please: Bottom metal DBM

I realy like APAs new bottom metal. Jered and Dave make great gear!