Rifle Scopes AI 34mm rings
- Thread starter MEDICGORDO
- Start date
Re: AI 34mm rings
I can check mine if you would like but I am using their 45moa one piece scope mount on both my 308 and 338. I have an adjustable check but have it bottomed out on the 308 but have the 338 up just a bit (not sure why that is). I have S&B 5-25's on both. Just to let you know, I tried to put a new double turn S&B in their 20moa mount but it hit the bottom of the mount before it was seated. Hope this helped but if not let me know if you would like me to measure.
I can check mine if you would like but I am using their 45moa one piece scope mount on both my 308 and 338. I have an adjustable check but have it bottomed out on the 308 but have the 338 up just a bit (not sure why that is). I have S&B 5-25's on both. Just to let you know, I tried to put a new double turn S&B in their 20moa mount but it hit the bottom of the mount before it was seated. Hope this helped but if not let me know if you would like me to measure.
Re: AI 34mm rings
I should have a more direct question but i have an ae with a 20moa USO pic rail.im going to use the scope on two rifles so im not going to use the ai mount.
I should have a more direct question but i have an ae with a 20moa USO pic rail.im going to use the scope on two rifles so im not going to use the ai mount.
Re: AI 34mm rings
I have an ae with a ferrel 20moa base and I'm running seekins meds with a ph5-25. It is the bare minimum for that optic and many people I k ow can't see down my scope.
We need to know what scope it is too to give a reccomendation..
I have an ae with a ferrel 20moa base and I'm running seekins meds with a ph5-25. It is the bare minimum for that optic and many people I k ow can't see down my scope.
We need to know what scope it is too to give a reccomendation..
Re: AI 34mm rings
s&b 5-25-56 i think you answered my question i was going to go with BO 1" max-50's or 1.25's.i knew what it would take to fit i was just worried about being to low for proper cheek weld.
s&b 5-25-56 i think you answered my question i was going to go with BO 1" max-50's or 1.25's.i knew what it would take to fit i was just worried about being to low for proper cheek weld.
Re: AI 34mm rings
My AI AW has a factory pic rail and works great with the one piece AI mount. I measured 1.40" from top of pic rail to center of scope. You could easily lower it .15" but I personally wouldn't go to 1" high rings, at least on my gun.
My AI AW has a factory pic rail and works great with the one piece AI mount. I measured 1.40" from top of pic rail to center of scope. You could easily lower it .15" but I personally wouldn't go to 1" high rings, at least on my gun.
Re: AI 34mm rings
Thanks Morgan i might need to go a little higher if yours is bottomed out on the 308.
Thanks Morgan i might need to go a little higher if yours is bottomed out on the 308.
Similar threads
