I have a gen 1 cykepod, prs legs with RRS clamp.
It is pretty loose, and getting looser, at the joint where it pans side to side.
It's not the pan set screw, I have tightened it down, it will pan under pressure that I have adjusted. Or I can tighten that set screw down hard and it won't pan, but still wiggles back and forth quite a bit. It feels like it's locked into a shaft internally but that shaft is loose.
Anyone know a way to tighten that down? It didn't used to do this, and my other one doesn't do this, so I'm missing something or there might be something wrong with it.
Any clue?
It is pretty loose, and getting looser, at the joint where it pans side to side.
It's not the pan set screw, I have tightened it down, it will pan under pressure that I have adjusted. Or I can tighten that set screw down hard and it won't pan, but still wiggles back and forth quite a bit. It feels like it's locked into a shaft internally but that shaft is loose.
Anyone know a way to tighten that down? It didn't used to do this, and my other one doesn't do this, so I'm missing something or there might be something wrong with it.
Any clue?