Gunsmithing Badger Inlet Picture?

[Dennis_in_VA]

I am looking for a picture of the bedding of a Badger 2008 action.

I saw one somewhere but CRS is preventing me from locating it.

Maybe Mark or Chad can help me out (I'd really appreciate it guys).

 

[excaliber]

Re: Badger Inlet Picture?

Just squirt some caulk under it and tighten down screws. It will go where needed.

 

[Dennis_in_VA]

Re: Badger Inlet Picture?

Yure funny Vestal..... Is that how you do your bedding jobs? LOL.

I need a picture of the finished product (comparing it to my latest patient or maybe I should say victim).

 

[toygunner]

Re: Badger Inlet Picture?

I think on Badger's site there is a diagram of the bedding for the m2008.

Look here:

http://badgerordnance.com/wp-content/uploads/downloads/2011/10/M2008-Short-action-Inlet.pdf

 

[Dennis_in_VA]

Re: Badger Inlet Picture?

I appreciate the effort TG, but I'm looking for a picture of a bedding job that someone has done. I want a picture showing the stock with the action removed showing the bedding compound and the clean-up cuts they amy have made with the end mill.

 

[LRI]

Re: Badger Inlet Picture?

Haven't bedded a badger yet, but it can't be much different than anything else.

Clay up your action. Once bedded the casting seams where the clay is will tell you where to make your clearance cuts.

Literally "cut by numbers" so to speak.

Good luck

C.

 

[Gray]

Re: Badger Inlet Picture?

Look exactly halfway down the page, several good pics in this thread.

http://www.snipershide.com/forum/ubbthreads.php?ubb=showflat&Number=3639085#Post3639085

 

[RADcustom]

Re: Badger Inlet Picture?

Better yet, click here and it will take you right to it.

http://www.snipershide.com/forum/ubbthreads.php?ubb=showflat&Number=3565804#Post3565804