Barrel Contour for Tikka in KRG Bravo?

[RabbitSlayer48]

Going to send a T3 to PacNor for a barrel chambered in 6mm Creedmoor. First time I have had a gun rebarreled. Not sure what contour would be good?

It will be in a KRG Bravo stock with a brake. I tend to like a longer barrel and a weight forward balance for all long guns. Thinking 27" and a JP Tank brake.

Gun will be primarily for shooting steel from a bench with a rear bag and bipod, It will also come out for some occasional prairie dogs and rock chucks. Might carry it on a short walk, but I have lighter guns if I am going any distance.

 

[PinesAndProjectiles]

Knowing your intended use, I would go MTU or M24. From the safe to the truck or the truck to the bench is a short walk with a heavy rifle.

 

[RabbitSlayer48]

Those are not listed as options. http://pac-nor.com/contours/

 

[PinesAndProjectiles]

The NBRSA would be just slightly larger than an MTU. MTU typically finishes around .920.

I think an M24 would be closer to the "Target Weight.".

Both of these are straight taper contours.

 

[spife7980]

I’d go 7

 

[Sniperwannabee]

Just call them on the phone a order a mtu or m24 and see if they will do it for you

 

[b6graham]

they have a section to make your own contour