Bergara, 34mm scope, .94" rings: anyone have a similar setup and can tell me height above bore?

[Winny94]

I'm away from my calipers - can anyone with a Bergara, 34mm scope, and ~.94" rings give me their scope height above bore?

Thanks

 

[Trigger Monkey]

The general rule of thumb that I use for height over bore with Remington actions and clones like the Bergara is 1" plus the ring height, it hasn't let me down yet.

 

[Another Casual]

Type of barrel and profile factor in too. A Savage or remage setup that's smaller at the shank and has a featherweight profile will have more room for the scope bell than a straight 1.250 bull, etc.

 

[Trigger Monkey]

Barrel profile plays a part if you're at the selecting scope rings part. From the sounds of it the OP already has rings and needs to know the height over bore to enter the data into a ballistic program, in which case barrel profile is irrelevant, only the distance from centerline to centerline. Even then you can be a 1/10" off or so and still be fine, output wise.

 

[JCARL]

1.89" with Seekins 34mm Lows (.92) so you should be 1.91"