Rifle Scopes Best unitized scope mount for USO SN3 5-25 TPAL?

Fred @ Bison Tactical

Bison Tactical
Commercial Supporter
Full Member
Minuteman
  • May 18, 2012
    1,820
    637
    Boulder, CO
    www.bisontactical.com
    Just saw another thread that the SPUHR single piece mounts don't fit the 34mm tubed TPAL's. If this is correct, what other single base mount does fit, and which of the fitting one is best (and why)?

    Or should I try to switch my order to a 35mm tube on my pending USO -- ie, are there 35MM tube SPUHR mounts that DO fit?
     
    Re: Best unitized scope mount for USO SN3 5-25 TPAL?

    What type of rifle are you outfitting--what height do you need? Our 1.45" high AADMOUNT in 35mm fits the TPAL beautifully.

    (Thanks to X-Navy for taking such a nice pic!)

    11291.jpg


    It works with a 34mm scope with our composite 34mm inserts. More info about the mounts in the sig.
     
    Re: Best unitized scope mount for USO SN3 5-25 TPAL?

    Ahh, while the question is still valid, I have switched my order with USO to the 35mm tube so I can run the SPUHR mount. Thanks to Lazy21 for being flexible!

    So, question is still good - if you have a 34mm USO tube already what other choices do you have, and how good are they? AADMOUNT, I know USO actually is selling a one piece mount also now...
     
    Re: Best unitized scope mount for USO SN3 5-25 TPAL?

    ahh - to answer the height, I am not sure yet. Barrel isn't yet on the action so I am not 100% sure. This is a Stiller TAC338 action with a 20MOA base. Don't think the barrel has been picked out yet. Was going to go with a Mark Channlyn, but I think there may be a delay, so the smith is checking what other options exist for delivery in a timely manner.
     
    Re: Best unitized scope mount for USO SN3 5-25 TPAL?

    Herofish

    You have the mounts pretty close.
    At Mile High in Denver, so you Can easaly go and check it up.
    However as I got drawings before I made the mounts ( we have Four different models 1,18" and 1,46" heigth and as 0 and 20 Moa)
    So with 35 it should be fine.

    34mm dont fit as they are all made around PM2 and those have much shorter maintubes.

    Håkan