Firearms Bighorn TL3 Rifle 6.5 Creedmoor - SOLD

[DairyDictator]

This was my comp gun for the past year. The barreled action has about 2500 rounds on it. The barrel is near end of service life and has plenty of firecracking in the bore, but it will still shoot down in the .3's to .5's with 147 ELD-M's seated a little long under 41.5 gr H4350 with Lapua SRP Brass. Factory loads shoot about .75-1 MOA. I believe the throat has worn down enough that the factory rounds are jumping further to the lands than they'd like to be. The full build sheet is listed below. It served me well, but I ended up liking the Impact action more, so I built a 6GT on an Impact.

Asking $2300 shipped to your FFL in a plano hard case.

Bighorn TL3 short action
-DLC Coating (shows lots of wear on the bolt)
-Tactical bolt knob
-AW mag cut
-Right hand
-20 MOA base

Triggertech Special set at ~ 1-1.5 lbs

Manners PRS-2 Elite GAP finish
-Front and back non rotating flush cups on left and right side
-Mini Chassis Gen 2
-Area 419 14" ARCA rail
-Inletted for TL3 but side has been opened up to accept an Impact 737 as well
-Barrel channel has been opened to accept M24 contour barrel
-Adjustable LOP spacer system with all plates that came with it
-1" Pachmeyer buttpad

Criterion Prefit 6.5 Creedmoor
- ~2500 rounds
- NSS Varmint contour straight taper
- 5/8x24 thread
- Black rattlecan finish

Area 419 Hellfire brake 6.5mm
-5/8x24 adapter

Tools
- Bighorn Invisinut and torque wrench
- Bighorn action wrench

 

[Ruskin]

PM sent

 

[DairyDictator]

Barreled action sold.