Where are you guys getting the roll pins from when you need a couple. I would imagine a 700 bolt and an impact bolt would use the same roll pin?
Thanks guys!!
Thanks guys!!
Gunsmithing Bolt ejector roll pin
- Thread starter LoanHarvey
- Start date
I would caution you to not assume anything. This is one particular area where literally everyone (manufacturers) are on their own page. Some use a roll pin and others use a solid. That can also change within a given series from a manufacturer.
The safe money here has 2 options:
Call the manufacturer and get the size or
Pin gauge the hole to determine its size, then source the right pin. Keep in mind the pin needs to have a slip/interference fit so it doesn't fall out.
McMaster Carr has a great selection but your going to be buying a bag full of em. Thankfully this stuff is pretty cheap.
Good luck.
The safe money here has 2 options:
Call the manufacturer and get the size or
Pin gauge the hole to determine its size, then source the right pin. Keep in mind the pin needs to have a slip/interference fit so it doesn't fall out.
McMaster Carr has a great selection but your going to be buying a bag full of em. Thankfully this stuff is pretty cheap.
Good luck.
