Comparator case for 6x47L

[BenjaminMartin6.5]

How do I make a comp case for 6mm? I have one for 6.5 that I bought from OTM Tactical, but what should I neck it down to?

 

[LawnMM]

Neck it down like you would any other case you plan to form 6x47 out of

 

[Ranger188]

Josh at Copper Creek will make you one.

 

[BenjaminMartin6.5]

Thanks guys, I was scratching my head and didn’t want to buy 2 or 3 neck bushings at $20 to get it right.

 

[Dstoenner]

Neck it down like you would any other case you plan to form 6x47 out of

Remember the bullet has to slide so you need an ID of maybe 244 so the bullet is free but not wobbly. Don't ask me how I know..

What I did was during breakin I took a couple of cases I didn't want because they were weight rejects and fired a full power load. I then kept them separate and didn't size them and made mine by drilling out the back and tapping the case. Works fine.

David

 

[LawnMM]

Little sandpaper does wonders

 

[Superjet]

Send me one of your fired pieces of brass and I'll make you one.

 

[padom]

Yep was gonna say the same. Send me a case and I can make you one

 

[BenjaminMartin6.5]

Thanks for the info and offers! I can drill and tap if that is an easy way. I have a lathe at work.

 

[padom]

Thanks for the info and offers! I can drill and tap if that is an easy way. I have a lathe at work.

It's very easy. Problem is the tap is non typical. You'll need to.buy one most likely.

 

[BenjaminMartin6.5]

Do you know what it is buy chance?

 

[Dstoenner]

Do you know what it is buy chance?

5/16X36 That is finer than 5/16 NF

David

 

[BenjaminMartin6.5]

Thank you, Sir.