Curtis Vector Screw backed out of hole near bolt release

[_Raining]

I have a Curtis Vector and I was installing a AW mag latch on the bane of my existence MDT ACC and the little screw that is in the hole by the bolt release on the Vector has seemed to vibrated itself back out.

First question, What is it for?

Second question, How do I fix this? Is it as simple as screw it all the way in till it bottom outs?

 

[spife7980]

This one? Looks like its to hold the bolt release in. And if its threaded then I would assume that you are intended to thread it in, yes.

 

[_Raining]

This one?

Yes, that is the one. The bolt release seemed unaffected by it being backed out a bit but I guess it wasn't enough to cause a problem.

 

[beretta_man11]

my axiom did the same., twice. I just screwed it in a little tighter, made sure the release still worked, and went on about my day.

 

[DangerRanger]

my axiom did the same., twice. I just screwed it in a little tighter, made sure the release still worked, and went on about my day.

Same for my vector

 

[kthomas]

Might be worth putting a little blue loctite on that fella

 

[Steel head]

Vibratite!