Defiance SA Action and XRS Chassis Alignment

[Tilting40s]

So this is my fist custom gun, wondering if the offset of the mag-well is ok and not a bit too rear-ward.

The reason I ask is I’d like to load my rounds further out to magazine length, but when I do the tip of the bullet (no matter the kind I use) gets caught under the action.

Is this something to even worry about? Thanks in advance

Defiance Tenacity 6.5 CM
XRS Chassis

 

[spife7980]

You need mags with a binder plate to keep them back from under it or you need to notch your feed ramp

 

[Tilting40s]

You need mags with a binder plate to keep them back from under it or you need to notch your feed ramp
View attachment 8168082

Of course I just found an identical thread about this exact issue and this same set up.