What is the best way/process for removing durakote from a hard anodized ar lower? I would rather not damage the hard anodize underneath but the duracoat color needs to go.
Thanks in advance, Craig
Thanks in advance, Craig
Gunsmithing Duracoat removal
Re: Duracoat removal
Some very good epoxy based stripper and elbow grease.
You can also soak it in a bucket of MEK and that will loosen it up depending on how well it was applied. This will allow you to scrub it off. Use gloves and a respirator with the MEK.
Either way the anodizing under the Duracoat will be stained the color of the Duracoat, not a big deal if you plan on re-finishing it.
Some very good epoxy based stripper and elbow grease.
You can also soak it in a bucket of MEK and that will loosen it up depending on how well it was applied. This will allow you to scrub it off. Use gloves and a respirator with the MEK.
Either way the anodizing under the Duracoat will be stained the color of the Duracoat, not a big deal if you plan on re-finishing it.
Similar threads
Precision Rifle Gear Camper Gun Rack
Accessories McMillan A6 Multicam