ERATAC Torque Specs

[QS-1911]

Recently picked up the ERATAC mount and was looking at the torque specs. 10-12Nm seems a little high. It would seem 55-65 in lbs should be more than enough. For those who have this mount what torque specs are you going with? I searched the threads throughout the forum but couldn't find a definitive answer. Thanks!

 

[GIXXER2000]

I have 2 ERA-TAC and I thought the same. 10nm =88.5 in lbs and 12nm =106 in lbs I set 60 in lbs and have never had an issue

 

[QS-1911]

I have 2 ERA-TAC and I thought the same. 10nm =88.5 in lbs and 12nm =106 in lbs I set 60 in lbs and have never had an issue

Gotcha! Thanks! Yea 88.5 in lbs is a tad much. I'll go with 60 in lbs and call it a day.