This is a factory Heckler & Koch 416 upper receiver. Made in Oberndorf; NOT an assembled parts build; NOT an MR556 cut-down.
OTB (Over the Beach) spec chamber with the extractor support stud.
550-600 rounds fired. I am the original owner; upper was purchased new.
"AG" date code (2006 production)
No barrel discoloration; minimal wear on the BCG.
Original A2 replaced with Vortex flash hider (has NOT been pinned)
Original handguard replaced with Remington RAHG (tight lock-up, no wobble); sling loops removed
Original charging handle replaced with Geissele Airborne CH
There are 2 small blems. One is on the left side at the bottom of the receiver; the other is near the charging handle on the right side. Again, the sling loops have also been removed for aftermarket rails.
NO TRADES
$4400 shipped/insured
OTB (Over the Beach) spec chamber with the extractor support stud.
550-600 rounds fired. I am the original owner; upper was purchased new.
"AG" date code (2006 production)
No barrel discoloration; minimal wear on the BCG.
Original A2 replaced with Vortex flash hider (has NOT been pinned)
Original handguard replaced with Remington RAHG (tight lock-up, no wobble); sling loops removed
Original charging handle replaced with Geissele Airborne CH
There are 2 small blems. One is on the left side at the bottom of the receiver; the other is near the charging handle on the right side. Again, the sling loops have also been removed for aftermarket rails.
NO TRADES
$4400 shipped/insured
