I got this idea for a FAL flash suppressor. Does anyone have the skills to actually set it up?
?
- Thread starter Switchblade
- Start date
You might have better luck in the gunsmith sub-forum Switch. I'm 100% sure I could set it up in the 6-axis mazak, if I had any idea what spirocore baffles are. Would it be a profitable use of the machine time is another important question I can't answer without knowing what spirocore is or the dimensions needed to cut it.
Spinning something 5" long, 1" diameter is not hard at all. There appears to be 1/2" diameter threads on one end. Rough guestimate of scale would be the threaded section is 1/2" long.
But for actually making something, more information is actually needed. Also, what are you wanting it made out of?
But for actually making something, more information is actually needed. Also, what are you wanting it made out of?
