I purchased a FN PBR last week with the 2 piece scope bases. I almost ran out of adjustment on my scope trying to boresight it. I put a strait edge on the front rail and noticed that the rear base sits lower than the front rail. Is this normal for this gun? Thanks.
Rifle Scopes FN PBR scope bases
- Thread starter Atom8
- Start date
Re: FN PBR scope bases
I wouldn't think so but I'm not sure. I had a PBR for a while with a factory base that worked fine. Mine came with a one piece. You might want to try an aftermarket base or contact FN (I've heard good and bad stories about CS) and ask.
I wouldn't think so but I'm not sure. I had a PBR for a while with a factory base that worked fine. Mine came with a one piece. You might want to try an aftermarket base or contact FN (I've heard good and bad stories about CS) and ask.
Re: FN PBR scope bases
I think so but do some checking just to makes sure. I had to sell mine to pay some bills and didn't buy any aftermarket items for it. My original plan had been to swap out the stock, trigger job, bed it, etc. but never got the chance.
I think so but do some checking just to makes sure. I had to sell mine to pay some bills and didn't buy any aftermarket items for it. My original plan had been to swap out the stock, trigger job, bed it, etc. but never got the chance.
Similar threads
