Hey guys hope your week is going well as we approach the holidays.
So I'm pretty sure I'm going to purchase the 21st century neck turning tool.
My question is about its use and where in your reloading step do you employ it.
My biggest concern is overworking brass. I don't for example want to full length size my brass, then use their mandrel so size the case mouth, only to have to resize it back down again to set neck tension.
Not sure if I'm explaining my question correctly so bare with me.
Right now I full length size without and expander. Then I set neck tension with a gauge pin. My hope was I could turn in between those 2 steps.
Any input always welcome.
Thanks!!
So I'm pretty sure I'm going to purchase the 21st century neck turning tool.
My question is about its use and where in your reloading step do you employ it.
My biggest concern is overworking brass. I don't for example want to full length size my brass, then use their mandrel so size the case mouth, only to have to resize it back down again to set neck tension.
Not sure if I'm explaining my question correctly so bare with me.
Right now I full length size without and expander. Then I set neck tension with a gauge pin. My hope was I could turn in between those 2 steps.
Any input always welcome.
Thanks!!