HNT 26 arca rail

[Guns&WhiteWater]

Does anyone know if the built-in arca rail on the HNT 26 is made to the same specs/exact same size as the RRS SOAR rails? I hated having to fiddle with bipod clamps in the past when moving them around on different rifles with different width pic rails from various manufacturers to get them to fit just right. I have been installing SOAR rails on my rifles lately and will do the same with the HNT by ordering the non-railed version if the railed version arca is not the same size. But I am hoping it is.

 

[redneckbmxer24]

Mine works with RRS stuff.

 

[Guns&WhiteWater]

Mine works with RRS stuff.

Good to hear. So it fits well without having to adjust the clamp?

 

[Franko]

I own an Atlas bipod which uses an RRS SC-ARC clamp. The clamp works perfectly on my HNT-26 and KRG Whiskey-3 ARCA rails without any adjustments.

 

[Guns&WhiteWater]

I own an Atlas bipod which uses an RRS SC-ARC clamp. The clamp works perfectly on my HNT-26 and KRG Whiskey-3 ARCA rails without any adjustments.

Thanks for the reply. I’ve got the same clamps on my Atlas and TBAC bipods. I did not want to have to adjust them and my anvil 30 clamp if the HNT 26 rail was under or over-sized. Standardization is so nice.

 

[Burdy]

Can someone measure the length of the ARCA section of the HNT 26 for me?

 

[Franko]

Can someone measure the length of the ARCA section of the HNT 26 for me?

About 8.5 inches.

 

[Burdy]

About 8.5 inches.

Thank you sir

 

[Guns&WhiteWater]

Installed an R-Lock rail over the built-in one. This came from Sawtooth Rifles and is made for the HNT26. Locks up tight on the tripod and will act as a sacrificial rail.